Rear end removal

Today Chela and I took a major step in the restoration of our old Alfa. We cut the damaged rear end of the car out. I've been spending a bit of time in the trunk over the past week and after drilling out the spot welds that run along the midsection of the tail panel and cutting the inner brace loose from the trunk floor we were ready. I clamped my new replacement panel on the rear of the car, traced the outline with a Sharpie, and turned on my plasma cutter. It didn't take more than 5 minutes and I was holding the extremely damaged rear panel in my hands.

Here's what the rear of the car looked like with the panel removed.

As you can see, I've got some pretty serious rust in the trunk panel. If I could find a good replacement trunk floor I'd buy one and weld it in, but I've yet to source that part. With the panel roughly removed I then turned to my Dynabrade angle grinder with a metal flap disc in it, and began slowly grinding metal away, stopping short of the Sharpie outline I'd made.

As I progressed I was able to get to a point where the rear bumper mounts were nearly flush with the indentation in the panel, indicating I was getting close to where I needed to be. I was able to temporarily hold the panel in place by installing the bolts that hold the bumper to the body, but this is where it gets tricky. Obviously cutting too much metal out would be disastrous so I need to go very slowly, make lots of measurements, and trial fit the panel after each pass.

I've also bolted the trunk lid back on to check the shut lines where it meets the top of the rear panel. Over the next few days I'll keep working on fitting that rear panel. Then I'll remove the rust from the lip of the trunk floor where it butts up against the inner part of the panel, primer it and start welding the panel in. It's really rewarding to remove rusted and damaged metal from an old car, and also to fit the new panel in place. I decided to start with the rear because this panel is not nearly as complex as the front, and I hoped I'd learn something without making too many mistakes.

Speaking of the front of the car, I found a used grill on eBay that is not perfect, but which should be a good candidate for re-chroming, assuming I can figure out how to get the stainless steel slats out without ruining the part. It looks to be an original grill and has none of the quality control issues that I've found in the reproductions. After getting it chromed it will no doubt cost as much as a new reproduction part, but hopefully it will look and fit much better.

Ciao!